![]() ![]() If your meter reads a connection between the cables, your wiring probably ok.Set your Ohm meter to read ohms or continuity and touch the probes to the wire in the center of each cable.Connect the short cable to the cable/antenna jack your TV was connected to.Connect the long cable to the outside jack and then bring the other end into the camper.Short Cable line (1 foot or less would be best).You can check the connection between the outside of your RV and the jacks on the inside with an ohm meter. I found another one behind the TV jack in the bedroom too. Here is a picture of a splitter I pulled out of the wall behind my booster. Unlike homes where the splitters are usually located in attics or basements where you can see them, RV manufacturers put the splitters in the walls behind the jacks. The wiring for your TVs comes in from a jack on the exterior, connects to the booster and then splits off to the other TV locations in the RV. For RV’s with multiple TVs try a different one and see if it works, if it does the problem is most likely with the connection to that specific TV or connection, if the other TV doesn’t work your problem is most likely closer to the booster. If the campground’s signal is good things get trickier. If it works you know the campgrounds signal is good. If your cable line is long enough, disconnect it from the side of your RV and bring it through a window directly to the input on the back of a TV. Check the campgrounds cable signalįor cable the next thing I would check is that the campgrounds connection is working. You might be picking channels from your antenna. Just make sure you check the channels to the campgrounds TV guide before switching the wires. If your cable starts working with the booster on you will have to remove the booster from the wall and switch the wires labeled Antenna and Cable. To test this just turn the switch to the opposite position and let your TV scan for channels again. One of the easiest checks is to see if your booster was wired backwards at the factory. If you made it through the first 2 steps and haven’t had any success, it’s time to check the wiring. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |